Check the UL label color before hanging outdoor Christmas lights

Unlit decorative lights held by plastic clips on a white porch railing
Illustration (AI-generated).

Outdoor Christmas lights need a label confirming outdoor use and a GFCI-protected power connection. On UL-listed decorative light strings, a red holographic label identifies indoor or outdoor use. Green identifies indoor use only. Check the set’s intended use before hanging an old indoor string on the porch.

Read the rating as well as the UL label

UL Solutions explains the label colors in its bulletin on decorative lighting strings. It evaluates these strings to UL 588, the seasonal and holiday decorative-lighting standard. The color guidance applies to that kind of UL label, not to any red sticker on a light set.

UL is one acceptable testing mark. The Consumer Product Safety Commission advises buying lights tested by a nationally recognized testing laboratory. For outdoor lights, it also says to check the label for outdoor certification. A set without a recognizable safety mark or a clear intended-use label is one to leave in the store.

Use GFCI protection outdoors

CPSC specifies a ground-fault circuit interrupter (GFCI)-protected receptacle or a portable GFCI for outdoor lights. Confirm that protection before connecting the strings. Don’t decide whether an outlet is protected just by looking for buttons on its face. If you can’t establish how it’s protected, have a qualified electrician check it.

Extension cords must be rated for their intended use and be in good condition. For the porch or yard, check the outdoor rating. Discard cords with cuts or fraying.

Follow the set’s connection limit

The National Fire Protection Association tells users to read the manufacturer’s instructions for the number of light strings that can be connected. Check the instructions for your set before joining strings end to end. Stop at that limit instead of adding another set because the run is almost long enough.

Turn off all light strings and decorations before leaving home or going to bed. NFPA gives this advice for holiday lighting indoors as well as outdoors.

Inspect before hanging

Check new sets as well as stored ones. CPSC says to discard lights with broken or cracked sockets, frayed or bare wires, or loose connections. NFPA recommends clips rather than nails to avoid damaging the cord.

Finish the inspection on the ground. A damaged set is easier to replace before you’ve attached it to the railing or roofline.

Sources

Basis

Research-based: written from the published sources listed above, primary: UL Solutions, U.S. Consumer Product Safety Commission. We have not used the products discussed ourselves, and any measurement quoted belongs to its source.

This article was created with the help of AI. How we work

← Back to the blog